Heartland VALUE Series Assembly Manual page 30

PARTS REQUIRED:
Pre - assembled
BEGIN
1
Measure 2-9/16" down from top plate doubler and mark at each side as shown.
Set gable unit on top plate. Fasten with (1) 2" nail on each side.
BE SURE GABLE IS CENTERED ON WALL BEFORE NAILING.
2
Continue nailing lower edge of panels to wall doubler with 2" nails spaced 6" apart.
3
Working inside, secure gable unit with (2) 3" screws angled into each AF at an angle (Fig. A).
NAIL FIRST
2-9/16"
2" (5,1 cm)
(6,5 cm)
Measure and
Mark
4 Continue securing panels to rafter with 2" nails spaced 6" apart.
Repeat STEPS 1 - 4 for the opposite side 10' gable (without window).
FINISH
Your gable units are now installed
GABLE INSTALLATION
DOUBLER
Fig. A
x8
x90
2" (5,1 cm)
6"
(15,2 cm)
3" (7,6 cm)
Screws
28
3" (7,6 cm)
AF
2-9/16"
(6,5 cm)
Measure and
Mark
NAIL FIRST
2" (5,1 cm)