Heartland VALUE Series Assembly Manual page 32

PARTS REQUIRED:
x1
3
Install 23-1/2" x 96" roof panel flush
to the installed panel and there is a
1/2" measurement on the gable end
rafter (Fig. A).
Secure panel with (1) 2" nail
in each corner.
2" (5,1 cm)
Nails
4
Maintain spacing between the center of the rafters
at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter,
as shown.
Move to the top of the panel and keep spacing
between the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
24-3/8"
(61,9 cm)
2" (5,1 cm) Nails
ROOF PANELS
23-1/2" x 96"
(59,7 x 243,8 cm)
NOTE:
Measurements from inside of gable panels
24"
(60,9 cm)
Flush
Fig. D
24"
(60,9 cm)
30
x10
2" (5,1 cm)
End Rafter
1/2"
(1,2 cm)
24-3/8"
(61,9 cm)
Fig. A
Gable