PARTS REQUIRED:
Two-Gusset
x3
Preassembled
One-Gusset
x2
Preassembled
BEGIN
Align rafters over the wall studs.
1
Check that you have the measurements shown.
Secure rafters with (2) 3" screws angled at each end (Fig. A, Fig. B).
Secure rafters on opposite side.
Maintain the measurements between rafters.
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
FINISH
Your rafters are now installed.
RAFTER INSTALLATION
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS
DIMENSIONS
ARE TO CENTER
24"
24-3/8"
(61 cm)
(62 cm)
Fig. A
x20
OF RAFTERS
24"
(61 cm)
ALIGN OVER
STUDS
3" (7,6 cm)
Screws angled
Flush to inside
into top plate
of panel
26
3" (7,6 cm)
24-3/8"
(62 cm)
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
Fig. B