Magtek ExpressCard 2000 Manual page 35
Instant issuance card personalization system hopper module replacement procedure
Hide thumbs
Also See for ExpressCard 2000:
- Hardware service manual (356 pages) ,
- User's installation and operation manual (84 pages) ,
- Preventive maintenance procedure (25 pages)
Table of Contents
Advertisement
3 - Hopper Module Replacement Procedure
33) Place your right finger into the loop the flex cable makes, pull the flex cable taut, and hold it there.
Make sure the cable is parallel to the top deck plate / edge of the device and does not have any bends,
twists, or kinks. If the cable is damaged or is mounted to the case incorrectly, it may need to be
replaced per D998200047 ExpressCard 2000 Hopper Flex Cable Replacement Procedure.
34) While holding the flex cable taut, use your left hand to press the flex cable straight back onto the
double-stick tape.
ExpressCard 2000| Instant Issuance Card Personalization System | Hopper Module Replacement Procedure
Page 35 of 42 (D99875700-30)
Advertisement
Table of Contents
Need help?
Do you have a question about the ExpressCard 2000 and is the answer not in the manual?
Questions and answers