Magtek ExpressCard 2000 Manual page 15
Instant issuance card personalization system hopper module replacement procedure
Hide thumbs
Also See for ExpressCard 2000:
- Hardware service manual (356 pages) ,
- User's installation and operation manual (84 pages) ,
- Preventive maintenance procedure (25 pages)
Table of Contents
Advertisement
3 - Hopper Module Replacement Procedure
19) VERY carefully pull the flex cable free from the double-sided foam tape just next to the connector.
The flex cable will be reused so it is important to not damage it.
20) Use your fingers to rub all foam tape residue off the connector end of the flex cable.
21) Gently push the hopper shuttle toward the front of the device, past the connectors on the top deck
plate.
ExpressCard 2000| Instant Issuance Card Personalization System | Hopper Module Replacement Procedure
Page 15 of 42 (D99875700-30)
Advertisement
Table of Contents
Need help?
Do you have a question about the ExpressCard 2000 and is the answer not in the manual?
Questions and answers