Table of Contents
Advertisement
6.3. Programming a Demo Design with the Lattice Diamond Programmer
The demonstration design is pre-programmed into the MachXO2/MachXO3 board by Lattice. If you have changed the
design but now want to restore the board to factory settings, use the procedure described below.
To program the MachXO2 device:
1. Install, license and run Lattice Diamond software. See
and licensing information.
2. Connect the USB cable to the host PC and the MachXO3 board.
3. From Diamond, open the Default_pattern_w_standby.ldf project file.
4. Click the Programmer icon.
5. Click Detect Cable. The Programmer detects the cable (Cable: USB2, Port: FTUSB-0). If the cable is not detected,
see the
Troubleshooting
6. Click the Program icon. When complete, PASS is displayed in the Status column.
© 2014-2022 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal.
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-EB-02051-2.3
section.
MachXO2 Breakout Board Evaluation Kit
http://www.latticesemi.com/latticediamond
Evaluation Board User Guide
for download
11
Advertisement
Table of Contents
