Configure The Local Service Control - Zte ZXHN H3600 Maintenance Management Manual

Parameter
Source IP/Destination IP
Protocol
Ingress
Egress
DSCP
3. Click Apply button to apply the changes.

5.4.3 Configure the Local Service Control

The section describes how to configure local service control.
Steps
Configure the Service Control-IPv4
1. On the main page of the ZXHN H3600, select Internet > Security > Local Service
Control to the Local Service Control page.
2. Click Service Control-IPv4 to open Service Control-IPv4 page, see
SJ-20201203151144-003 | 2021-06-16(R1.0)
Description
Source/Destination destination IP address.
Select the protocol that needs to filter packets.
By default, it is Any.
Specify the data traffic direction. The Ingress option and
egress option cannot be the same.
If the ingress is LAN, the egress should be a WAN or 3G

connection. The data traffic direction is upstream.
If the ingress is a WAN or 3G connection, the egress

should be the LAN. The data traffic direction is down-
stream.
Specify the data traffic direction. The Ingress option and
egress option cannot be the same.
If the ingress is LAN, the egress should be a WAN or 3G

connection. The data traffic direction is upstream.
If the ingress is a WAN or 3G connection, the egress

should be the LAN. The data traffic direction is down-
stream.
A DSCP is specified for the TOS byte in the IP header of each
packet to indicate the priority. Range: 0–63.
5 Configure the Internet
Figure 5-19.
35