Zte ZXHN H3600 Maintenance Management Manual page 29

Table 5-2 3G Configuration Process
Steps
1
2
3
4
Note
What to do when 3G device is not ready?
1. Check whether the dongle is plugged in.
2. If the device is already plugged in, please check whether the USB is contacted well.
3. If the device is still unrecognized, maybe it has been damaged. Please replace the
device.
Steps
1. Insert 3G device.
2. On the main page of the ZXHN H3600, select Internet > Status > 3G > Mobile Net-
work to the Mobile Network page. The signal strength can verify the network card is
plugged, as shown in
Figure 5-6 Mobile Network
3. On the main page of the ZXHN H3600, select Internet > WAN > 3G to the 3G Con-
nection page, as shown in
SJ-20201203151144-003 | 2021-06-16(R1.0)
Operations
Insert 3G device.
Check the 3G device status.
Create a 3G WAN connec-
tion.
Check the 3G connection sta-
tus.
Figure
Figure
Instructions
Null.
The signal strength can verify whether the network card is
plugged.
Click
new 3G connection.
The IP address getting from carries can verify that the 3G
WAN Connection based on IPv4 was completed success-
fully.
5-6.
5-7.
5 Configure the Internet
on the page, and create a
23