Zte ZXHN H3600 Maintenance Management Manual page 31

Parameter
Auto-disconnected without traffic
NAT Switch
5. On the main page of the ZXHN H3600, select Internet > Status > 3G to the 3G
Working Mode page, as shown in
Figure 5-8 3G Working Mode
6. Set the parameters and click Apply. For a description of the parameters, refer to
ble 5-4.
Table 5-4 3G Working Mode parameters
Parameter
3G Mode
Backup Interval
Recovery Primary Uplink Interval
Result
On the main page of the ZXHN H3600, select Internet > Status > 3G to the 3G Con-
nection Status page, as shown in
SJ-20201203151144-003 | 2021-06-16(R1.0)
Description
On Demand

Setting this parameter when Connection Mode is On De-
mand.
Select on/off NAT switch function.
Figure 5-8.
Description
Enables or disables the 3G Working function.
Sets the interval after which services are switched to the
standby line when the active line is interrupted.
Sets the interval after which services are switched back to
the active line when the active line is recovered.
Figure 5-9.
5 Configure the Internet
Ta-
25