Changing The Image Quality Settings - AGFA DRY 3.4 Reference Manual

40 | DRY 3.4 | Advanced Operation (key-operator mode)

Changing the image quality settings

Topics:
• Changing general image quality settings - Film calibration
• Changing general image quality settings - Default densitometer
• Changing Image quality setting for a modality - Selecting a lookup table
• Changing Image quality setting for a modality - Changing the
Interpolation
• Changing Image quality setting for a modality - Changing the maximum
density (Dmax)
Changing general image quality settings - Film calibration
1. On the 'Change setting' screen, press the Down key four times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
2. Press the Confirm key to select 'General'.
The 'General settings' screen will appear:
3. Press the Confirm key to select 'Film calibration'.
The 'Select default for film calibration' screen is displayed:
This setting is by default set to ON and will apply to every modality.
The current setting is marked with an *.
4. Press the Up/Down arrow keys to select the preferred film calibration
default.
When the setting is ON, the printer will ask you to enter the calibration
frequency:
2604A EN 20180322 1454