Drystar 5301, Drystar 5302 | Advanced Operation (key-operator mode) | 37
Changing the image quality settings
Topics:
•
Changing general image quality settings - Film calibration
•
Changing general image quality settings - Default densitometer
•
Changing Image quality settings for a modality - Selecting a lookup
table
•
Changing Image quality settings for a modality - Changing the
interpolation
•
Changing Image quality settings for a modality - Changing the
maximum density (Dmax)
Changing general image quality settings - Film calibration
1. On the Change settings menu, press the Down key four times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
2 <Modality name>
3 <Modality name>
2. Press the Confirm key to select 'General settings'.
The 'General settings' screen is displayed:
3. Press the Confirm key to select 'Def. film calib.'.
This setting is by default set to ON and will apply to every modality. The
currently active setting is indicated with a '*'.
4. Press the up/down key to select the preferred film calibration default.
When the setting is ON, the printer will ask you to enter the calibration
frequency:
Enter the calibration frequency by means of the up/down key.
2830F EN 20210520 0952