JLG 10MSP Service And Maintenance Manual page 34

SECTION 5 - MAST COMPONENTS
5.2 MAST COVER - INSTALL/REMOVE
Mast Cover Installation
1. Mast Cover
2. Screws and Washers (a)
Platform shown without right side rails for illustra-
tive purposes only.
Note: (a) Apply Loctite #242 to threads before final tightening.
5-2
3. Platform Console Mount-
ing Screws
– JLG Lift –
5.3 PLATFORM ASSEMBLY - INSTALL/
REMOVE
Platform Installation
1. Platform/Material Tray
Assembly
2. Tie Straps for Platform
Console Harness
Platform shown without right side rails and plat-
form floor cutaway for illustrative purposes only.
Note: (a) Raise platform and remove the hex head screw/wash-
ers and nuts (item 4).
While under the platform, unplug the wiring harness to
the foot enable switch and the entry gate interlock
switches from the platform junction box.
Using suitable lifting equipment carefully lift the plat-
form/material tray assembly off the mast assembly.
3. Countersunk Flat Head
Socket Screws/Washers
and Locknuts
4. Hex Head Screws/Wash-
ers and Locknuts (a)
3121228