JLG 10MSP Service And Maintenance Manual page 10

SECTION 1 - MACHINE SPECIFICATIONS
NO/TYPE
ITEM COMPONENT
LUBE POINTS
Fill To Full Line on
1 Hydraulic Oil Dipstick - 5 Qt.
Reservoir
2 Swivel Raceways
3 Mast Chains 2 - Per Section
Key to Lubricants: MPG - Multipurpose Grease
HO - Hydraulic Oil - ISO-Vg grade 32, 46
GEAR OIL - Good Quality Worm Gear Oil - SAE 90 - AGMA#5 - EP Compounded
CL - Chain Lube. Use a good quality chain lubricant
Notes: (a) Be certain to lubricate like items on each side of the machine.
(b) Recommended lubricating intervals are based on normal use. If machine is subjected to severe operating conditions,
such as a high number of cycles, location, corrosive/dirty environment, etc., user must adjust lubricating requirements accordingly.
(c) Prior to checking hydraulic oil level, operate machine through one complete cycle of lift function (full up and down). Failure to do so
will result in incorrect oil level reading on the hydraulic reservoir.
1-4
Lubrication Points.
Table 1-6. Lubrication Intervals for Various Components
(a)
LUBE/METHOD
HO - Check Hyd. Oil
Level
HO - Change Hyd. Oil
— MPG
CL - Brush or Spray
– JLG Lift –
(See Table Below)
(b)
INTERVAL
3 6 1
MONTHS MONTHS YEAR YEARS
✔
✔
✔
COMMENTS
2
Check fluid level every day. (c)
Change hydraulic oil every 2 years.
Upper: Permanently Sealed.
Lower: Repack if Serviced.
Inspect, lubricate if dry or rusting.
3121228