JLG 10MSP Service And Maintenance Manual page 21

Hide thumbs Also See for 10MSP:

Table of Contents

Motor/Brush Cover - Remove/Install

1. Motor/Brush Cover (a)

2. Cover Screws (b)

REMOVE THE MOTOR COVER CAREFULLY, THE (SHORT) POWER LEADS INSIDE THE COVER FROM THE (+/—) POSTS ARE SOL-

DERED TO ATTACH CLIPS WHICH ARE FASTENED TO THE BRUSH CARRIER ASSEMBLY WITH SCREWS (ITEM-5). RAISE THE

COVER STRAIGHT UP - REMOVE THE SCREWS - THEN HINGE THE COVER UP (SEE CENTER ILLUSTRATION) AND PRY THE CLIPS

OFF OF THE BRUSH CARRIER ASSEMBLY TO COMPLETELY REMOVE THE MOTOR COVER.

NOTE: (a) Once cover screws are removed, you may need to tap lightly around the edge of the top cover to separate it from the motor

housing. Read the note above before attempting to remove the cover.

(b) These steel screws are threaded into the aluminum valve body, do not overtighten.

3121228

Motor/Brush Cover - Removal/Installation

3. Washers

4. Power Leads to Lead Clips (Soldered)

– JLG Lift –

SECTION 3 - BASE COMPONENTS

5. Power Lead Clip Attach Screws

3-23

Table of Contents

3121228