Manufacturer / Service Address - Automation Dr. Nix CarCheck System PLUS User Manual

CarCheck System PLUS
11.1.2 CarCheck PLUS Software
Error
Image is displayed
distorted.

11.2 Manufacturer / service address

The CarCheck PLUS gauge and the CarCheck PLUS software are manufactured by:
Automation Dr. Nix GmbH & Co. KG
Robert-Perthel-Straße 2
D-50739 Cologne, Germany
+49 221 917 455 – 0
Phone
Fax +49 221 171 221
http://www.automation.de
http://www.carchecksystem.com
The CarCheck System PLUS is manufactured using high quality components and state-of-the-art
manufacturing methods. Careful intermediate inspections and a quality management system certified
in accordance to the DIN EN ISO 9001 standard ensure the optimum workmanship of the device. The
software was programmed and tested with greatest care. However, errors cannot be excluded
completely due to the individual components and settings of a computer, which my influence
performance of the program.
If you happen to experience any error with your gauge or the software, remove the batteries or exit the
program and contact the customer service of Automation Dr. Nix GmbH & Co. KG stating and
describing the type of error.
If you have specific questions regarding its use, please contact your point of sale or write directly to
the address mentioned above.
Possible cause
Image does not have the required
4:3 aspect ratio.
Suggested solution
Use image from proper source or
use adequate software to fit image.
Appendix
43/44