Table of Contents
Advertisement
CarCheck System PLUS
1 Preamble
1.1 About this User Manual
This user manual is intended for anyone operating the CarCheck system. All local regulations
regarding the handling of electrical devices must still be observed. We assume a basic knowledge of
the procedures, possibilities, and limits of coating thickness measurement. For the installation and
operation of the CarCheck PLUS software, a general knowledge of computers and the Windows
operating system is necessary.
1.2 Intended Use
The CarCheck PLUS gauge provides non-destructive coating thickness measurement of non-
magnetic coatings such as lacquer, paint, chrome, or zinc on steel or iron, as well as of electrically
insolating coatings such as lacquer, paint or aluminum oxide (anodizing) on non-iron metals.
The CarCheck PLUS software provides means to exchange documentation and measurements with
the CarCheck PLUS gauge. It does not support other devices.
The device has not been approved for any other use.
If you have questions regarding the handling of the device or the software not answered in this
manual, please contact the point of sale or write to:
Automation Dr. Nix GmbH & Co. KG
Robert-Perthel-Straße 2
D-50739 Cologne, Germany
www.carchecksystem.com
1.3 Legal Notice
Disclaimer
We guarantee that, to the best of our knowledge, this product is free of defects and works as
advertized and stated in this user manual. We do not guarantee or promise any other product
attributes or the fitness of the product for any other than its intended use. We do not accept liability if
the product is used for purposes that are not covered by the chapter Intended use of this user
manual.
Trademarks and Registered Trademarks that are used in this document are property of their
respective owners and are used without special notice.
Copyright
© Copyright Automation Dr. Nix GmbH & Co. KG Cologne, Germany. All rights reserved.
This document may not be reproduced in whole or in part without explicit permission of Automation Dr.
Nix GmbH & Co. KG. User manuals are for personal use only.
EU Directives
The coating thickness gauge meets all requirements as specified in the European directive
89/336(regarding electromagnetic compatibility).
Appendix
3/44
Advertisement
Table of Contents
Need help?
Do you have a question about the CarCheck System PLUS and is the answer not in the manual?
Questions and answers