Connecting The Emulator System; Connecting The Serial Interface Cable; Connecting The Power Cable - Renesas M30800T-CPE User Manual

2.4 Connecting the Emulator System

How to connect the cables to the emulator system is shown in Figure 2.5 below.
Figure 2.5 Connecting the emulator system

(1) Connecting the Serial Interface Cable

Connect the serial interface cable (included) to the serial interface connector (J2) and the serial port
of the host machine (see Figure 2.5).

(2) Connecting the Power Cable

Connect the power supply for the emulator to the power connector (J1). The specifications of the
power supply for the emulator are listed in Table 2.6.
Table 2.6 Specification of power supply of emulator
Power supply voltage
Figures 2.6 and 2.7 show the specifications of the power connector (J1) and the applicable plug,
respectively.
Figure 2.6 Specification of power connector
Notes on Connecting the Power Supply of Emulator:
Connect the serial interface
cable to J2 connector.
To host machine
To power supply for emulator
Connect the power cable
to J1 connector.
DC 5.0 V ±5%, 2 A
• Be careful about the polarity of the power supply. Connecting to the wrong electrode
could destroy internal circuits.
• The power cable included in this product package is colored red (+) and black (-).
• Do not apply a voltage other than the specified voltage of the product (5.0 V ±5%),
because it may cause burn injuries and the failure of internal circuits.
Figure 2.7 Specification of applicable plug
CAUTION
( 23 / 52 )