Table of Contents
Advertisement
Chapter 3. Changing the Settings
3.1 Using the Emulator without the Target System
How to use the emulator without the target system is shown below.
(1) Set the "MCU power supply select jumper" to INT side and "MCU power voltage select jumper"
3.2 Using the Emulator with the Target System
How to use the emulator with the target system is shown below.
(1) Set the "MCU power supply select jumper" to EXT side (see page 20).
(2) Connect the target system (see page 22).
(3) Connect the power supply for the emulator (see page 23).
3.3 Using the P8
/X
7
How to use the emulator when using the P8
(1) Set the "P8
3.4 Using the P8
/X
7
How to use the emulator when using the P8
(1) Set the "P8
to 5.0 V side (see page 20).
The target MCU operates with 5.0 V of power supply voltage supplied from the emulator.
The setting of "MCU power voltage select jumper" is invalid.
Connect the LCC probe on the lower board of the emulator to the LCC socket (option) or the pitch
converter board (option).
As the emulator cannot supply power to the target system, provide the target system with a
separate power supply from that of the emulator.
Pin as a Port
CIN
/X
select switch" to P87 side (see page 20).
7
CIN
Pin as Sub-Clock Input
CIN
/X
select switch" to XCIN side (see page 20).
7
CIN
/X
pin as a port is shown below.
7
CIN
/X
pin as sub-clock input is shown below.
7
CIN
( 30 / 52 )
Advertisement
Table of Contents
Troubleshooting
