Starting Up The Emulator - Renesas M30800T-CPE User Manual

2.2 Starting Up the Emulator

The procedure for starting up the emulator is shown in Figure 2.3. For details, refer to each section
hereafter. And, when the emulator does not start up normally, refer to "Chapter 5. Troubleshooting"
(page 37).
Figure 2.3 Procedure for starting up the emulator
Select the MCU power supply select jumper.
Set the P8 /X select switch.
7 CIN
Connect the serial interface cable.
Connect the power supply for emulator.
Connect the target system.
Turn on the emulator.
Check the LED of emulator.
Start up the emulator debugger.
Specify the operating environment.
Debug the program using M3T-PD308M.
Set the jumper according to the connection to the
target system.
- When not connected: INT
- When connected:
* The MCU power voltage select jumper should be
fixed to 5.0 V.
Set the switch according to the usage of P8
- For a port:
- For XCIN input: XCIN
Connect the serial interface cable to the serial
interface connector (J2) of emulator and the serial
port of the host machine.
Connect the power supply to the power connector
(J1). Specifications of emulator power are 5.0 V
±5%, 2 A.
Connect the target system to the LCC probe at the
bottom of emulator (when necessary).
Recheck the connection, and turn on the emulator.
When the target system is connected, turn on the
target system too. Turn them on as simultaneously
as possible.
Check "POWER" and "SAFE" of the system status
LEDs and "POWER" and "CLOCK" of the target
status LEDs light. When the target system is not
connected "POWER" does not light.
Start up the emulator debugger M3T-PD308M.
In the INIT dialog box of emulator debugger M3T-
PD308M, specify the following, and press the OK
button.
- MCU file: "M30800.MCU"
- Communication port: Select the serial port
where the emulator is connected.
Emulator debugger M3T-PD308M offers various
debugging functions. For details on M3T-PD308M,
refer to the online manual of M3T-PD308M.
( 21 / 52 )
EXT
/X pin.
7 CIN
P87