Renesas M30800T-CPE User Manual page 20

(3) System reset switch
By pressing the system reset switch, you can initialize the emulator system. Table 2.3 shows the
functions of the system reset switch depending on the state of emulator.
Table 2.3 Functions of the system reset switch
State of Emulator
When the user's program is halted
When the user's program is executed
Note on System Reset Switch:
• After pressing the system reset switch, reboot the emulator debugger M3T-PD308M.
Otherwise the display of emulator debugger and the actual value (in the emulator)
may not match.
• When the emulator debugger does not start up normally even after rebooting, turn
off the emulator and then turn on again.
Initializes the emulator and waits for commands from the
emulator debugger.
Stops the user's program, initializes the emulator, and
waits for commands from the emulator debugger.
CAUTION
( 20 / 52 )
Function