14. REMOVING An E-Wand FROM A TWIST GROUP
In some instances, you may want to remove an E-Wand from a previously
created Twist Group. To remove an E-Wand:
Press and hold the PROGRAMMING BUTTON on the E-Wand you wish
to remove from the group until you hear a SINGLE BEEP (1), then release.
Once more, press and hold the PROGRAMMING BUTTON until you
hear another SINGLE BEEP (1), then release.
Repeat this process to remove any additional desired E-Wands from the
group.
In some instances, you may want to add an E-Wand to an existing Twist
15. ADDING An E-Wand TO A TWIST GROUP
Group. To add an E-Wand:
Press and hold the PROGRAMMING BUTTON on the E-Wand you
originally designated as the master until you hear a SINGLE BEEP (1),
then release.
On any E-Wand you wish to add to the group, press and hold the
PROGRAMMING BUTTON until you hear a SINGLE BEEP (1), then
release.
After all additional E-Wands have been initialized, return to the master
to press and hold its PROGRAMMING BUTTON again until you hear a
SINGLE BEEP (1).
All added blinds will jog (if the positions have been set) or beep (if the
positions have not yet been set).
37