Current E-WAND Installation Manual And User's Manual page 13

3. Test Fit the Blind Mount
Perform a test fit of the HORIZONTAL
BLIND MOUNT by snapping the mount
onto the E-Wand [Fig. 3.4]. Slide the
mount up or down along the CONTROL
HOUSING until your blind's tilt gear stem
and the E-Wand ATTACHMENT HOOK
can be seen through the cutout in the
blind mount. Be sure the bottom of the
horizontal blind mount is resting above
the two sensor switches [Fig. 3.5].
Verify that the blind mount can rest
completely flush to the header [Fig. 3.6]
AND that the blind slats resting in the
fully open position are not touching the
E-Wand [Fig. 3.7].
Proper positioning will have the E-Wand
protrude out slightly to not make contact
with the blind slats and have the blind
mount make full contact with the
headrail [Fig. 3.8 and Fig. 3.9]. If there is a
fit issue, proceed to Step 4.
Figure 3.4; Snap on
Blind Mount
Figure 3.6; Tilt Stem
Protrudes from
Headrail Preventing
a Flush Mount
Figure 3.8; Proper
positioning without
valance
13
Figure 3.5; Proper
Positioning
Figure 3.7; Blind
Slats Touch
E-Wand
Figure 3.9; Proper
positioning with
valance