Current E-WAND Installation Manual And User's Manual page 10

2. Install the Horizontal Tilt Converter
Determine the size and shape of the rod
located in your header.
Locate the ADAPTER from the selection
supplied which matches your rod shape
and size and snap into the HORIZONTAL
TILT GEAR [Fig. 2.4].
Figure 2.4; Snap in Adapter
Place the gear's stem through the
opening in the header and slide the rod
through the gear to its original position
[Fig. 2.5]. If a rod pin or the end brackets
were removed while removing the
corded tilt gear, replace back into their
original position.
Figure 2.5; Slide Stem through Header
You have now converted your tilt mechanism. You may now proceed to
Installing the E-Wand.
10