Current E-WAND Installation Manual And User's Manual page 36

2. Assign the Master E-Wand and Close the Group
Once you have initiated the linking
sequence on EACH E-Wand, choose an
E-Wand that will be centrally located in
the group to designate as the "master".
Press and hold THIS E-Wand's
PROGRAMMING BUTTON again until
Figure 13.2; Press and Hold
Programming Button
you hear a SINGLE BEEP (1) [Fig. 13.2].
You have now completed linking your
E-Wands and have created a Twist Group.
To confirm the group has been properly
created, each programmed E-Wand in the
group will jog [Fig. 13.3]. Any E-Wands
in the group that have not had their slat
positions programmed will play a tune.
Figure 13.3; Jog
The ability to create a twist group will time out after FIVE (5) minutes of
inactivity. If you have mistakenly initiated grouping on an E-Wand, simply
twist the TWIST HANDLE to remove from programming mode.
36