3. Attach the E-Wand to the Vertical Blind
Pull down on the VERTICAL BLIND
MOUNT'S bellows to expose the E-Wand
ATTACHMENT HOOK. Hook the E-Wand
ATTACHMENT HOOK onto the existing
blind's tilt gear stem [Fig. 5.4].
Release the blind mount to allow the
bellows to extend upwards toward the
header, covering the attachment hook.
Be sure the slat attachment can move
through the open slot in the blind mount
[Fig. 5.5].
4. Replace First Slat
Carefully replace the reinforced slat
back onto the slat attachment hook by
reversing the steps to remove the slat
[Fig. 5.6]. Be sure the slat is oriented
the same as the other slats within the
assembly.
You have now completed installing your E-Wand onto your vertical
Figure 5.5; Proper Positioning
Figure 5.6; Reattach Vertical Slat
blinds.
21
Figure 5.4; Hook on E-Wand