2. Set the First Position- Full Closed Down
Twist the E-Wand TWIST HANDLE [Fig.
4.2] to move the slats of the blind to the
FULL DOWN position, then release the
TWIST HANDLE.
Be careful not to over tighten slats, as
over tightening can cause damage to
the blind.
Press and hold the PROGRAMMING
Figure 4.2; Twist
Figure 4.3;
BUTTON until you hear a SINGLE BEEP
Blinds to Full
Push and Hold
(1) [Fig. 4.3], then release.
Closed
Programming
Button
16