2. Set the First Position- Full Closed Left
Twist the E-Wand TWIST HANDLE [Fig.
6.2] to move the slats of the blind to
the FULL CLOSED LEFT position, then
release the TWIST HANDLE.
Be careful not to over tighten slats, as
over tightening can cause damage to
the blind.
Press and hold the PROGRAMMING
Figure 6.2; Twist
Figure 6.3;
BUTTON until you hear a SINGLE BEEP
Blinds to Full
Push and Hold
(1) [Fig. 6.3], then release.
Closed Left
Programming
Button
23