Current E-WAND Installation Manual And User's Manual page 20

1. Remove Twist Wand and First Slat
Move the blind slats to the fully open position, then remove the manual twist
wand from the vertical blinds.
Remove the first vertical slat by carefully
pushing the slat upward and then
sideways [Fig. 5.1].
Use the included VERTICAL BLIND
REINFORCEMENT TAPE to reinforce the
top of the first vertical slat [Fig. 5.2].
2. Install the Vertical Blind Mount onto the E-Wand
Install the VERTICAL BLIND MOUNT on
the E-Wand by sliding the clear plastic
bellows over the ATTACHMENT HOOK
until it fits snuggly on the E-Wand frame
[Fig. 5.3]. Install the mount so that the
sensor switches will be facing the inside
of the room.
Figure 5.1; Remove first vertical slat
Figure 5.2; Reinforce vertical slat with
slat reinforcement tape
Figure 5.3; Install Blind Mount
20