Current E-WAND Installation Manual And User's Manual page 14

4. Optional - Make Any Necessary Adjustments
The blind mount must have a secure
connection to the header. Based on
E-Wand positioning [Fig. 3.6, Fig. 3.7,
Fig 3.8 and Fig. 3.9], it may be necessary
to add the supplied EXTRA ADHESIVE
STRIPS to your blind's header to build
the mounting attachment outward [Fig.
3.10].
If the HORIZONTAL BLIND MOUNT
extends beyond the top or the side of the
blind's header, use scissors to trim the
HORIZONTAL BLIND MOUNT to fit [Fig.
3.11]. If you have a valance, make sure
the top of the neck of the HORIZONTAL
BLIND MOUNT is even with or slightly
below the bottom of the valance.
5. Secure Blind Mount
Now that you have determined the final
position of the HORIZONTAL BLIND
MOUNT, verify the header is clean and
dry and that the tube of the blind mount
is snapped into place on the E-Wand, then
remove the backing on the adhesive strip
[Fig. 3.12] and firmly press to attach it to
the blind's header.
You have now completed installing your E-Wand onto Horizontal Blinds.
Figure 3.10; (Optional) Build out Header
Figure 3.11; (Optional) Trim Blind Mount
Figure 3.12; Remove Backing from
Adhesive Strip to Attach it to Header
14
to Fit