Current E-WAND Installation Manual And User's Manual page 12

1. Detach Original Tilt Wand
Move the blind slats to the fully open position, then remove the manual twist
wand from the horizontal blinds.
If your blind has an open hook for the
original tilt mechanism as opposed to
a closed eyelet, slide the plastic WAND
HOOK SLEEVE over the tilt hook to cover
the hook's gap. Leave enough room for
the E-Wand ATTACHMENT HOOK to se-
curely connect [Fig. 3.1].
2. Attach the E-Wand
Mount your E-Wand [Fig. 3.2] by
connecting or
ATTACHMENT HOOK to your blind's tilt
gear stem or hook. Carefully push up the
plastic RETAINING SLEEVE, [Fig. 3.3].
Rotate the E-Wand until the two SENSOR
SWITCHES are in front and facing into
the room.
inserting the
Figure 3.1; Slide Hook Sleeve onto Stem
slat
Figure 3.2; Hook
Wand onto Tilt Stem
12
Figure 3.3; Push up
Retaining Sleeve