Programming E-Wand Vertical Slat Positions - Current E-WAND Installation Manual And User's Manual

6. PROGRAMMING E-WAND VERTICAL
SLAT POSITIONS
You must program in the open and close limits on the E-Wand prior to the
E-Wand being able to move. Limits are set to prevent any over-torquing of
your blinds.
When programming the E-Wand, you will be listening for audible beeps to
assist you through the programming steps. We recommend you minimize
the noise within the room while programming the E-Wand to best hear these
beeps.
During the programming phase, if an error is made, the E-Wand will play
a short tune. This means you must restart the programming steps for that
E-Wand.
1. Place the E-Wand into Slat Position Programming Mode
Before entering programming mode, verify your blind slats are in the full
open position. If they are not in the full open position, move them to full open
now.
To place the E-Wand into the Slat Position
Programming Mode, press and hold the
PROGRAMMING BUTTON until you hear
a DOUBLE BEEP(2), then release [Fig.
6.1].
Note: Prior to hearing a DOUBLE BEEP
Figure 6.1; Press and Hold Programming
(2), you will hear a SINGLE BEEP (1).
Button
After hearing the DOUBLE BEEP (2),
release.
The E-Wand is now in Slat Position
Programming Mode.
22