Current E-WAND Installation Manual And User's Manual page 31

3. Pair E-Wand
On any unit that you would like to pair
to the bridge, press and release the
programming button three times without
hearing a beep [Fig 8.4]. The E-Wand
should start beeping to indicate it is in
Zigbee Pairing mode.
The green LED on the bridge will flash to
Figure 8.4; Press and release
programming button three times.
indicate the E-Wand has been paired. The
E-Wand will jog to confirm.
If you have additional devices you would
like to add, repeat Steps 2 & 3.
Figure X -Green LED will flash to indicate
If the E-Wand does not jog, try putting the
successful pairing.
unit into pairing mode again. You have 5
minutes until the bridge times out of
pairing mode.
If the pairing is not successful again, try a
Master Reset on the E-Wand [pg. 39].
31