Current E-WAND Installation Manual And User's Manual page 24

3. Set the Second Position- Full Open
Twist the E-Wand TWIST HANDLE [Fig.
6.4] in the OPPOSITE direction than the
first phase of programming to move the
slats to the FULL OPEN position, then
release the TWIST HANDLE.
Press and hold the PROGRAMMING
BUTTON. You will hear a DOUBLE BEEP
(2) [Fig. 6.5], then release.
Note: During twisting, if you move past the full open position, do not
To get out of programming mode, power cycle the unit by partially unscrewing
twist the opposite way back to full open. Instead, restart programming.
and re-tightening the battery cap. You have successfully power cycled when
you hear a tune.
4. Set the Third Position- Full Closed Right
Twist the E-Wand TWIST HANDLE again
in the SAME direction [Fig. 6.6] so the
slats reach the FULL CLOSED RIGHT
position. Be careful not to over tighten
the slats.
Press and hold the PROGRAMMING
BUTTON. You will hear a TRIPLE BEEP
(3) [Fig. 6.7], then release.
Figure 6.4; Twist
Blinds to Full
Figure 6.6; Twist
Blinds to Full
Closed Right
24
Figure 6.5;
Push and Hold
Open Programming
Button
Figure 6.7;
Push and Hold
Programming
Button