Connectors, M9037A Pxie Embedded Controller - Keysight Technologies S9101A Startup Manual

3. 2. 4 Connectors, M9037A PXIe Embedded Controller
S9101A 5G Multi-Band Vector Transceiver, Startup Guide
Status LEDs
PWR (Green)
SSD (Amber)
Link (Green)
LAN (White),
USR (Grey)
Video/Dual Display Ports
Connectors
USB 2.0 and 3.0
Connectors
Connectors
LAN 1 and LAN 2
Connectors
LAN Connector
Top LED (Amber)
LAN Connector
Bottom LED (Off)
Bottom LED (Green)
Bottom LED (Amber)
LAN Connectors,
Top and Bottom
LEDs (Off)
LAN RST (Reset) Button
Trig (PXI Trigger In/Out)
Connector
GPIB
Connector
PCIe
Connector
3 Review Hardware Components
On, indicates power supply
to embedded controller is good.
Flashes when Solid State Drive is active.
Indicates PCIe Link status:
Off = No link;
Blinking @ 1 Hz = Gen1 speed
Blinking @ 2 Hz = Gen2 speed
On steady = Gen3 speed
Both LEDs are reserved for Keysight use only.
Two, Dual Mode DisplayPort++ connectors can
support either a DisplayPort or DVI-D monitor
Four, USB 2.0 (Type A)
Two, USB 3.0
Two, 10/100/1000BASE-T
(RJ-45) Gigabit Ethernet ports
Active, blinks if accessing IO
LAN Speed: 10 Mbps
LAN Speed: 100 Mbps
LAN Speed: 1000 Mbps
Network link not established
or system is powered off.
Reserved for Keysight use only.
SMB (m) snap-on,
bi-directional trigger connector for routing an
external trigger signal to/from PXI backplane
GPIB (Micro-D 25-pin)
x8 Gen 3 PCIe IPASS connector for controlling
a second PXIe or AXIe chassis or RAID storage
23