Verifying X-Apps Software Controls The S9101A; Verify The X-Apps Software Controls The S9101A At 3 Ghz - Keysight Technologies S9101A Startup Manual

5g multi-band vector transceiver

Hide thumbs Also See for S9101A:

Table of Contents

6 Verify Operation

6. 1 Verifying X-Apps Software Controls the S9101A

1. Connect an RF loop-back cable from RF In to RF Out connectors on the

RF Transceiver, located on the Rugged Front Panel.

(This loop-back cable is NOT included with the S9101A.)

2. If it is not already running, start the Modular TRX software and

review the interface; this interface is referred to as a Mode:

This process must be repeated for each M9410A and its selected

X-Apps software pair in a system.

This connection can be made using a cable with two adapters.

For example, a cable with adapters (or equivalent) can be used:

one 5063-1530 RF Cable, SMA (m) to SMA (m), 152.4 mm (6.0 in) and

two 1250-1250 Adapters, SMA (f) to Type-N (m)

The Modular TRX interface can be started as follows:

Select the Start menu (lower-left corner icon)

> Scroll down to "K" applications

> Select the Keysight Modular Transceiver drop-down arrow

> Scroll down the list and select LaunchModularTRX

Each Mode looks different and has its own collection

of measurement capabilities, controls, windows, and SCPI commands.

Each Mode runs within a screen (there can be multiple screens).

Screens are shown as tabs across the top of the interface.

IQ Analyzer (Basic) Mode is included with the S9101A

and appears as a tab with the label IQ Analyzer 1.

S9101A 5G Multi-Band Vector Transceiver, Startup Guide

Table of Contents

Table of Contents