Table of Contents
Advertisement
Safety & Environmental Information
Instrument Maintenance
Instrument Maintenance
Cleaning the Instrument
Cleaning the Connectors
Cleaning connectors with isopropyl alcohol shall only be done with all cables
disconnected, and in a well-ventilated area. Allow all residual alcohol moisture
to evaporate, and the fumes to dissipate prior to energizing the instrument.
14
Disconnect the M1740A from all cables before cleaning. Use a dry cloth or one
slightly dampened with water to clean the external case parts. Do not attempt
to clean internally.
Keep isopropyl alcohol away from heat, sparks, and flame. Store in a tightly
closed container. The alcohol shall not be stored, or left open, in the area of the
equipment. Use isopropyl alcohol with adequate ventilation to prevent the
combustions of fumes or vapors.
Avoid contact with eyes, skin, and clothing, as isopropyl alcohol causes skin
irritation, may cause eye damage, and is harmful if swallowed or inhaled. It may
be harmful if absorbed through the skin. Wash thoroughly after handling. In case
of spill, soak up with sand or earth. Flush spill area with water. Dispose of
isopropyl alcohol in accordance with all applicable federal, state, and local
environmental regulations.
In case of fire, use alcohol foam, dry chemical, or carbon dioxide; water may be
ineffective.
Getting Started Guide
Advertisement
Table of Contents
