Positioning Settings - HMS Networks Anybus Wireless Bolt LTE User Manual

Positioning Settings

5.9. Positioning Settings
Before You Begin
Use the positioning function to locate the position of the Bolt LTE.
For example, the Bolt LTE position is available and can be retrieved from the Bolt LTE via REST API.
By default, Positioning Service is Disabled.
Procedure
To activate Positioning Service:
1. On the Positioning Settings page, select Enable from the Positioning Service drop down menu.
Figure 22. Positioning Service, Enabled
2. In the left sidebar menu, click Save and Reboot.
Bolt LTE automatically reboots for the setting to take effect.
Result
Figure 23. Example, Current Position information
In Current Position you can view the following information.
Current Position
Positioning Service State
Valid Position
Latitude
Longitude
Accuracy
SCM-1202-164 Version 1.2
Description
When the Positioning Service is:
• Enabled the status is Active.
• Disabled the status is Disabled.
Yes: The satellite coverage is sufficient to provide a position.
No: The satellite coverage is insufficient to provide a position. This can occur:
• at startup, before the Bolt LTE has found enough satellites to provide a position.
• if the Bolt LTE is installed in a location where the satellite coverage is poor.
The latitude of the Bolt LTE current location
The longitude of the Bolt LTE current location
The closeness of the measured location to the actual location of the Bolt LTE.
® ™
Anybus Wireless Bolt LTE
Page 29 of 60