Table of Contents
Advertisement
9.5.
Raising the mast
Tools needed:
- Self-amalgamating tape
5.1.
Checklist
1.
Mast placed on trampoline with the spreaders
facing down.
2.
All stays and trapeze wires are untangled and in
the right order.
3.
Shrouds are attached to mast and boat.
4.
Shrouds are on maximum length.
5.
Trapeze wires are attached to mast and boat.
6.
No overhead wires.
7.
All lines are on the trampoline and cant hook on
anything
8.
Boat is on level ground or bows are pointing
down the slope.
9.
Bridle is connected to the boat.
10.
Bridle fore stay connection is prepared.
11.
Raising the mast is done with no less than 2
persons.
Before raising the mast the boat should be steady on
level ground. If the surface is not level, point both
bows downhill. If the boat is on a trailer be sure it
is tied down and the trailer tongue is secure to the
hitch!
CAUTION: Check for overhead wires and be sure the
area behind the boat is clear of people! A mast which
comes in contact with electrical power lines can
cause serious injury or death!
71.
Advertisement
Table of Contents
