Trampoline Track On Hull - Nacra 500 MK2 Assembly Manual

1.3.

Trampoline track on hull

1x
1.
Slide the front of the trampoline into the track of the
front beam. The front top has a pocket opening in the
middle. Check if the top points up.
2.
Make sure the trampoline is centered
Pulling the trampoline in can be heavy, this becomes easier
over time when the trampoline stretches a bit. You can use
soap on the sides of the trampoline to lubricate.
3.
Loosen all crossbar bolts.
Tools needed:
- Torque wrench
- 5/16 or 8 mm hex socket
- Dishwasher soap
6mm
1x
Rear lace line
4.
Use dishwasher soap to lubricate the sides of the
trampoline.
5.
Ideally with two persons, slowly and evenly pull the sides
into the tracks on the hulls.
Check if the trampoline does not get stuck at the
front edge of the track. Pulling hard when this
happens can damage your trampoline.
3mm
15.