Table of Contents
Advertisement
6.4.
Adjustable trapeze wires (optional)
Tools needed:
- 3mm allen key
1.
Connect the shackle to the top of the cam cleat.
2.
Feed the longer line through the bottom hole of the
cam cleat and tie of with a figure 8 knot.
3.
Feed the other end of this longer line through the
trapeze block and back up through the cam cleat. So
that the remaining end can be hooked in te cleat.
4.
Tie of this longer line with a
5.
Feed the shorter line through the hook and tie it off
with a figure 8 knot. Make sure minimally 4 cm of rope
is left after the knot to prevent slipping.
6.
Feed the other end of the shorter rope though the
trapeze block.
7.
Slide the stopper on. And secure it with a stopper knot.
8.
Finish the adjustable trapeze by making a figure 8 knot
4 cm from the end of the shorter rope.
9.
Connect the adjustable trapeze wires to the trapeze
line using the shackle
The shorter line needs to be cut of diagonally to fit
through the hook.
46.
x 4
x 4
Minimal:
4 cm
Advertisement
Table of Contents
