Front Panel Message - Dynamically Set Params Read Only - Printronix Network Interface Card User Manual

Chapter 5
Unix Troubleshooting Tips
9. At the system prompt, enter:
store tcpip from default
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway
parameters to the desired values.
ETHERNET,
To reset all Integrated NIC TCP/IP values to the factory defaults
WLAN when access is impossible, contact your Printronix service
representative for assistance.
12. If the Web browser access does not work, telnet into the NIC
as root. Enter the following command:
config http on
If you are still experiencing difficulty accessing or browsing the
printer, contact the Customer Solutions Center for further
assistance.
Front Panel Message – Dynamically Set Params
Read Only
This is not an error. It is an informational message warning that the
IP address has been dynamically set by either dhcp, rarp, or bootp.
To assign a static IP address, turn off the rarp, bootp, and dhcp on
the adapter. Use the following procedure:
1. Telnet to the adapter. Login = root, password = (Enter key)
Telnet commands are:
store tcpip 1 opts -rarp -bootp -dhcp
save
reset
Wait two minutes for the adapter to reset.
2. Program the IP address, Subnet Mask and Gateway (if
required) from the front panel.
154
reset the NIC.