Miscellaneous Commands - Printronix Network Interface Card User Manual

list var
List all pre-defined variables including any newly created ones.
Any of these defined variables can be referenced in a string by
placing a "$" before the variable name (e.g., set model m1
trailer $FF).
list dhcp
List all DHCP information for the NIC provided that DHCP is
enabled.
list lpd
List the Line Printer Daemon (LPD) information, such as
weahter the bytecount is enabled or disabled.

Miscellaneous Commands

These commands do not fall under any specific section of the
command shell, but they are used quite frequently.
save [default]
Save the current settings to flash memory so they are available
after power cycles. Sysinfo, destination, model, logpath,
variable, user, and I/O port settings will be saved. If
is specified as well, factory settings will be saved, overwriting
any new settings you have configured.
reboot
Perform a warm boot or hardware reset to simulate a power-on
reset. This restores current settings to those stored in flash
memory, since the flash memory settings will be read and
loaded into memory upon bootup.
reset
Perform a warm boot or hardware reset to simulate a power-on
reset. This restores current settings to those stored in flash
memory, since the flash memory settings will be read and
loaded into memory upon bootup.
load [default]
Load the settings stored in flash memory and use them as the
current or working settings. If default is specified as well,
factory settings will be loaded.
Miscellaneous Commands
default
339