Printronix Network Interface Card User Manual page 324

Chapter 15
Complete Command List
set ifc
Example: set ifc <ifnum> up|down
Set state of the specified network physical interface up or
down. <ifnum> is the interface number for the NIC device.
set logpath <logpath> name <new_name>
Example: set logpath l1 name pagecount
Change the current name of the logpath (<logpath>) to a new
name as indicated by <new_name>. These names are case
sensitive.
set logpath <logpath> type [[-]job] [[-]user]
[[-]cksum] [[-]printer] [[-]ioport]
Example: set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done
within this <logpath>. The options are:
job
user
cksum
printer
ioport
set logpath <logpath> port <TCP-port>|email|syslog
Example: set logpath l3 port 2000
Determine where the log information should be sent for a print
job or attached printer. The choices are:
TCP-port
email
324
Job ID, username, etc.
User ID along with three messages per job
about start and finish.
16-bit checksum value to confirm integrity of
data printed.
For special printer feedback.
Printer error messages determined through
the parallel port pins.
TCP port number ranging from 1024 to
65000.
Particular user's email address. This address
is set using the set sysinfo email
emailname@IPaddress or
emailname@domain.com command.