Printronix Network Interface Card User Manual page 43

Wireless NIC Configuration Using The Control Panel
•
Ant. Diversity
This is used to select the antenna for communication. It is
recommended to set to "Diverse" for the NIC to detect for optimal
communication. It can also be set to "Primary" or "Auxiliary".
•
Preamble
This is the preamble used in the wireless packets. It is
recommended to set to "Default" so that the NIC can detect the
correct preamble. The preamble is approximately 8 bytes of the
packet header generated by the AP is and attached to the packet
prior to transmission. The preamble length is transmission data rate
dependent. The "short" preamble is 50% shorter than the "long"
preamble. Transmit power is 0–100%. It must match the Access
Point's preamble configuration.
•
Power Mgmt
This option allows you to set power-save mode and sleep time. A
value specifying the sleep time in milliseconds will be provided. If
set to zero, power-save mode will be disabled.
•
Transmit Power
This option allows you to specify the power level used by the
wireless card to send network packets to the access point. Transmit
power is specified as a percentage of full pwer (0 – 100%).
•
Internat. Mode
When enabled, the Wireless option adapts to international
frequency requirements in Europe.
•
Auth Method
This feature allows the user to select the authentication method
used for the wireless network interface. The options include Open,
Shared, Kerberos, and LEAP.
43