Troubleshooting - Printronix Network Interface Card User Manual

Chapter 5
SCO Setup
6. From a shell prompt, use this command to test the printer:
#lp -dprint_name file_name
where print_name is the name of the printer you created and
file_name is the name of an appropriate file to test print.

Troubleshooting

This installation procedure assumes that the NIC adapter is
configured with the correct IP address, subnet mask and gateway
(if required). In addition, the administrator can ping and telnet to the
NIC adapter from the server console.
NOTE: If this is not the case, use the printer front panel or the
142
If it is the system default, then all jobs submitted without a
printer name will go to this printer. If it is not the system default,
it must be specified when printing. Type y or n and press Enter
or Return.
The printer is now installed and ready to print.
IPAssign utility to configure the NIC adapter before
proceeding.