Wireless Nic Configuration Using The Control Panel - Printronix Network Interface Card User Manual

Wireless NIC Configuration Using The Control Panel

•
Gateway Address
This is the gateway IP addresses that have four segments. They
are displayed as SEG1, SEG2, SEG3, and SEG4 which can be set
to any value in the range of 0 to 255.
•
DHCP
The DHCP option allows you to obtain host server IP addresses
when powering onto the network. The DHCP can be configured to:
•
Enable – each time you power on, the host server
automatically assigns you a different address (if the IP address
has not been previously assigned).
•
Disable – You choose the host server IP address. After the
selection, the IP Address remains fixed even after you reboot.
Wireless Parameter Configuration
Certain "WIRELESS PARAMS" must be configured to match the
Access Point settings:
NOTE: The "ETHERNET PARAMS" are configured the same way
as the 10/100 Ethernet external NIC. Please refer to the
NETWORK SETUP menu in the User's Manual.
•
Signal Strength
This menu displays the strength of the wireless signal.
NOTE: This is a display value only and cannot be changed.
41