Printronix Network Interface Card User Manual page 258

Chapter 11
Configuring On AS/400 As An IPDS Printer
NOTE: The lines in bold in Figure 33 are not used by PSF/400.
3. The following parameters are recommended:
a. PSF configuration (PSFCFG)
b. IPDS pass through (IPDSPASTHR)
c. Activate release timer (ACTRLSTMR)
d. Release timer (RLSTMR)
Configuring PSF With CRTDEVPRT On V3R7 And
Above
This section describes how to create a printer device description.
1. At the AS/400 command line, enter a command in the form:
CRTDEVPRT DEVD(printer_type) DEVCLS(*LAN) TYPE(*IPDS)
Where printer_type (e.g., T5000, P5000, L5520)is the
model of your printer.
258
Instead, PSF/400 uses the information entered in the
device description screen.
The name used for this PSF configuration object. The
name must match the user-defined object name
(USRDFNOBJ) in the printer DEVD.
To print SCS files, specify *YES, PSF/400 transforms SCS
into IPDS before printing.
Specifies the point at which the release timer (RLSTMR) is
activated. Set to *NORDYF.
Specifies the amount of time to wait before a session or
dialog is released without terminating the writer. The
ACTRLSTMR parameter specifies when this timer is to be
activated. Set the parameter to a value at least equal to the
TIMEOUT value on the printer. The recommended value is
*SEC15.
MODEL(0) LANATTACH(*IP) AFP(*YES) PORT(5001)
FONT(11) FORMFEED(*CONT)
RMTLOCNAME('128.9.12.134')
USRDFNOBJ(AFP/5000NETPRT *PSFCFG)
TEXT('printer_type NETWORK PRINTER')