Front Panel Message - Dynamically Set Params Read Only - Printronix Integrated Network Interface Card User Manual

Appendix A
Unix Troubleshooting Tips
To add/delete a TCP access list entry, refer to "TCP Access Lists"
on page 259.
NOTE: When the following procedure is used, the TCP access list
To reset all Integrated NIC TCP/IP values to the factory defaults
when access is impossible, contact your Printronix service
representative for assistance.
If the Web browser access does not work, telnet into the NIC as
root. Enter the following command:
config http on
If you are still experiencing difficulty accessing or browsing the
printer, contact the Customer Solutions Center for further
assistance.
Front Panel Message – Dynamically Set Params
Read Only
This is not an error. It is an informational message warning that the
IP address has been dynamically set by either dhcp, rarp, or bootp.
To assign a static IP address, turn off the rarp, bootp, and dhcp on
the adapter. Use the following procedure:
1. Telnet to the adapter. Login = root, password = (Enter key)
Telnet commands are:
store tcpip 1 opts -rarp -bootp -dhcp
save
reset
Wait two minutes for the adapter to reset.
2. Program the IP address, Subnet Mask and Gateway (if
required) from the front panel.
280
will be cleared, but all IP addresses will need to be entered
again after the procedure is complete.