Table of Contents
Advertisement
Chapter 4 – Administrator Configuration
Referring to the above table, you can easy calculate the number of live
streams supported by the system in concrete scenarios. Take a Small model
system that supports four resources. If there is an ongoing live streaming
sending video at 720p 30 fps and recording video at 1080p 30 fps/720p 60 fps,
using two rates and single window layout, it occupies three resources on the
system. Then there is one resource free, which allows for running one live
stream at CIF/4CIF/720p 30 fps, using a single rate and single window
layout concurrently.
The following table shows the maximum capacity of the Polycom® RSS™
4000 systems when perform the live streaming of different parameters:
Table 4-6
Recording with Live Streaming Properties
Recording
Live Streaming
Resolution
Resolution
(People Video)
(WMV File)
CIF/4CIF/
CIF/4CIF/
720p 30 fps
720p 30 fps
1080p 30fps/
720p 30 fps
720p 60 fps
Network Service
IP Setting
On the IP Setting page, you can configure parameters to be used for network
communication, including system IP address, DNS server, NAT server and
speed/duplex modes for LAN ports.
To configure LAN port parameters:
1
2
Table 4-7
Parameter
Obtain an IP Address
Automatically (DHCP)
4-8
Live streaming maximum capacity
Rates Used
1
2
1
2
Click System Config>IP Setting in the menu bar at the top of the page.
On the IP Setting page, configure the following parameters:
IP Setting Parameters Description
Description
If the user network is configured with a Dynamic Host
Configuration Protocol (DHCP) server, select this option to
automatically obtain the IP address.
Note: This option is not recommended as the address
assigned by the DHCP server could change over time.
Maximum Capacity
Video Layout
Small
Single Window
4
Dual Window
2
Single Window
2
Dual Window
1
Single Window
2
Dual Window
1
Single Window
1
Dual Window
0
Medium
Large
6
8
3
4
3
4
1
2
3
4
2
2
2
2
1
1
Advertisement
Table of Contents
