System Test - ActronAir QUE QTW-1000 Installation And Commissioning Manual

(5) System Test

Touch the fifth circle, 'System Test'.
1
Touch to start system test.
2
Touch 'Test 1: Zone detection'
3
Touch 'Start' and wait until the system finish zone test.
4
When finished, display will show the number of zones
5
connected to the system.
a) Shows test result for zoned system
b) Shows test result for non-zoned system.
NOTE:
Ensure that the number of zones connected to the system is shown on the
zone detection test summary. If not, check for any loose connections or
defective zone motors, then run zone detection test again.
23